CostBuildrPlaster Material Estimation Guide
Plastering is one of the largest finishing activities in a house, covering all interior and exterior walls and ceilings. Accurate material estimation ensures you have enough cement and sand on hand for continuous work without over-ordering. This guide covers single-coat and two-coat plaster calculations.
Plaster Thickness Standards
Interior walls typically receive a single 12 mm coat of plaster using a 1:4 or 1:6 (cement:sand) ratio. Exterior walls get a two-coat application: a 15–20 mm base coat (1:4) followed by a 6–8 mm finish coat (1:3). Ceilings receive a single 10–12 mm coat at 1:4.
The richer the mix (more cement), the stronger and more crack-resistant the plaster, but also the more expensive. Interior walls in dry areas can use 1:6; bathrooms, kitchens, and exterior walls should use 1:4 for better moisture resistance.
Step-by-Step Calculation for 100 Sq Ft
For 12 mm plaster on 100 sq ft of wall: wet volume = 100 × 0.04 ft (12 mm) = 4 cft. Dry volume = 4 × 1.33 = 5.3 cft (plaster uses a 1.33 factor instead of 1.54 for concrete because plaster has less void space). Using 1:4 ratio: cement = 5.3/5 = 1.06 cft = 0.85 bags. Sand = 5.3 × 4/5 = 4.24 cft.
For a full house, calculate total wall and ceiling areas: a two-story 5 marla house has roughly 5,000–6,000 sq ft of plaster area (both sides of walls plus ceilings). At 0.85 bags/100 sq ft, that's 42–51 bags just for interior plaster. Exterior plaster with a thicker coat adds 15–25 bags more.
Tips for Quality Plaster Work
Wet the wall surface thoroughly before plastering—dry bricks absorb water from the plaster, causing cracking and weak bonding. Apply plaster in even strokes using a straight edge and check with a spirit level. Cure plaster by spraying water for at least 7 days.
Common plastering defects: crazing (fine map cracking from too much cement or inadequate curing), debonding (plaster separating from the wall due to dry surface), and uneven thickness causing visible bulges under paint. Using clean, well-graded sand and maintaining correct water content prevents most issues.
Veelgestelde vragen
How much cement for plastering 100 sq ft?
For 12 mm thick plaster at 1:4 ratio: approximately 0.85 bags of cement (50 kg) per 100 sq ft. For 20 mm thickness: about 1.4 bags per 100 sq ft.
What is the best mix ratio for interior plaster?
1:4 (cement:sand) is the standard for interior walls and gives good strength and workability. 1:6 can be used for non-wet areas to save cement. For bathrooms and kitchens, always use 1:4 or richer.
How long should plaster be cured?
Cure for at least 7 days by spraying water 2–3 times daily. Inadequate curing is the leading cause of plaster cracking and debonding. In hot weather, increase curing frequency to prevent rapid moisture loss.